Specialists in Acoustic, Access and Leisure Flooring Systems
01274 533311  .  info@durabella.co.uk
PRODUCT DESCRIPTION
Agglomerated Cork for Impact and Airborne Noise Insulation of Floating slabs.

PACKAGING
1m x 10m x 8mm
*Other sizes available upon request

ACOUSTICAL RESULTS
(ISO 140 & 717)
∆Lw = 21dB
(ITeCons ACU 242/09)

THERMAL PROPERTIES
(ISO 8301)
Thermal Conductivity: 0.038 W/m˚K
Thermal Resistance:    0.210 m²˚K/W

PHYSICAL AND MECHANICAL PROPERTIES
(ISO 7322)
Surface weight:  1.5Kg/m²
Dynamic Stiffness: >55 MN/m³
Tensile Strength: 200 KPa
Recovery >90%
Load Bearing: up to 3.000 Kg/m³
Durability: Lifetime of the Building

GENERAL INSTALLATION INSTRUCTIONS
The following installation instructions are recommended by Durabella Acoustics Limited, but are not intended as a definitive project specification. They are presented in an attempt to be used with recommended installation procedures of the flooring manufacturers.

Room Conditions
Temperature >10˚C / Room moisture content < 75%

Subfloor
All subfloor work should be structurally sound, clear and level. The moisture content of the subfloor should not be more than 2.5% (CM) by weight measured on concrete subfloors.

Perimeter Insulation Barrier
Install a perimeter insulation barrier vertically around the entire perimeter of the room with width equal to that of the floor build up. This is highly recommended in order to avoid lateral propagation of impact noise. Spot adhere the strips to the wall using acrylic glue or a bead of silicone sealant (do not forget the edges of pipes, ducts etc).

Installation Instructions for DuraCork U32
Unpack the DuraCork U32 at least 24h before the installation and store it in the room where the installation will take place. Cut and trim the DuraCork U32 to the desired length and install directly over the subfloor with crown of the rolled materials up (removing eventual trapped air). Butt the DuraCork U32 directly against the insulation perimeter barrier already installed. Proceed to cover the entire floor making sure that the joints are butted tight.

After completion the DuraCork U31 should cover the entire flooring area without gaps and with joints securely taped. An insulation vapour barrier (p.e. foil) covering the entire flooring area MUST be installed prior to the screed. Install it, minimum 150mm wide vertically and overlapping it, minimum 100mm (use an adequate tape to fix it). After completion, the insulation vapour barrier should cover the entire DuraCork U32 area without any gaps. Never mechanically fasten the DuraCork U32 and/or the p.e. foil barrier with screws, nails or staples as this will severely diminish the performance of the insulation barrier.

Screed and Final Flooring
Cast a suitable screed over the loose laid PE foil previously installed over the product. Always follow manufacturers recommended installation instructions.
DuraCork U32
Nature’s Perfect Under Screed
Under Screed
Screed Isolator  .  Recycled
Increases Floor Thermal Insulation
Very Easy to Handle And Long Term Resilience
100% Natural and Sustainable Product
Very Flexible