Specialists in Acoustic, Access and Leisure Flooring Systems
01274 533311 . firstname.lastname@example.org
Two Laminated Layers (Agglomerated Cork & Recycled Rubber) for Top Impact Noise and Thermal Insulation of Ceramic Tiles and Stone.
915mm x 610mm x 9.5mm
*Other sizes available upon request
(ISO 140 & 717)
∆Lw = 20dB
Thermal Conductivity: 0.070 W/m˚K
Thermal Resistance: 0.136 m²˚K/W
PHYSICAL AND MECHANICAL PROPERTIES
Specific weight: 370-450 Kg/m³
Tensile Strength: >600 KPa
Durability: Lifetime of the Building
GENERAL INSTALLATION INSTRUCTIONS
The following installation instructions are recommended by Durabella Acoustics Limited, but are not intended as a definitive project specification. They are presented in an attempt to be used with recommended installation procedures of the flooring manufacturers.
Temperature >10˚C / Room moisture content < 75%
All subfloor work should be structurally sound, clear and level. The moisture content of the subfloor should not be more than 2.5% (CM) by weight measured on concrete subfloors.
Perimeter Insulation Barrier
Install a perimeter insulation barrier minimum 35mm wide vertically around the entire perimeter of the room. This is highly recommended in order to avoid lateral propagation of impact noise. Spot adhere the strips to the wall using acrylic glue or a bead of silicone sealant (do not forget the edges of pipes, ducts, etc). Before the installation of the skirting boards, the insulation strips must be levelled (trimmed) to the height of the tiles.
Installation Instructions for DuraCork T93
Unpack the DuraCork T93 at least 24h before the installation and store it in the room where the installation will take place. A properly sized V-notched trowel and polyurethane flooring adhesive should be used to glue the AcoustiCORK T93 to the concrete slab. Always follow the glue manufacturers recommended instructions.
Lay the DuraCork T93 sheets, with the rubber/cork side facing down into the bed of adhesive applied. Butt the sheets tightly against the perimeter insulation barrier already installed. Proceed to cover the entire floor making sure the joints are butted tight, without gaps and securely taped. Roll with a roller the floor area in both directions to make sure the sheets are firmly embedded in the adhesive.
Use polyurethane based adhesive. Always follow manufacturers recommended installation instructions.
Top Performance Impact Noise Reduction Underlay
Ceramic/Stone Tiles . Thermal . Acoustic/Impact
Top Impact Noise and Thermal Insulation in One Product
Installed Directly Under the Final Floor
Enhances Walking Comfort
High Durability and Long Term Resilience