Specialists in Acoustic, Access and Leisure Flooring Systems
01274 533311  .  info@durabella.co.uk
PRODUCT DESCRIPTION
Recycled Rubber Underlay for Impact Noise and Thermal Insulation of Hardwood Floors.

PACKAGING
1m x 15m x 3mm
*Other sizes available upon request

ACOUSTICAL RESULTS
(ISO 140 & 717)
∆Lw = 20dB
(ITeCons ACU 128/10)

THERMAL PROPERTIES
(ISO 8301)
Thermal Conductivity: 0.140 W/m˚K
Thermal Resistance:    0.021 m²˚K/W

PHYSICAL AND MECHANICAL PROPERTIES
(ISO 7322)
Specific weight: 650-750 Kg/m³
Tensile Strength: >450 KPa
Compression: 20%
Recovery >90%
Durability: Lifetime of the Building

GENERAL INSTALLATION INSTRUCTIONS
The following installation instructions are recommended by Durabella Acoustics Limited, but are not intended as a definitive project specification. They are presented in an attempt to be used with recommended installation procedures of the flooring manufacturers.

Room Conditions
Temperature >10˚C / Room moisture content < 75%

Subfloor
All subfloor work should be structurally sound, clear and level. The moisture content of the subfloor should not be more than 2.5% (CM) by weight measured on concrete subfloors.

Perimeter Insulation Barrier
Install a perimeter insulation barrier minimum 35mm wide vertically around the entire perimeter of the room. This is highly recommended in order to avoid lateral propagation of impact noise. Spot adhere the strips to the wall using acrylic glue or a bead of silicone sealant (do not forget the edges of pipes, ducts, etc). Before the installation of the skirting boards, the insulation strips must be leveled (trimmed) to the height of the wood.

Installation Instructions for DuraCork T22
Unpack the DuraCork T22 at least 24h before the installation and store in a room where the installation will take place. Use a properly sized V-notched trowel and acrylic glue to flue the DuraCork T22 to the concrete slab. Always follow the glue manufacturers recommended instructions.  

Cut the DuraCork T22 to the desired length and install directly over the subfloor with crown of the rolled materials up, removing all trapped air. Butt the DuraCork T22 directly against the insulation perimeter barrier already installed. Put the loose laid material back. Using a properly sized V-notched trowel, apply acrylic glue to the concrete slab. Gently, return the pulled back material to its measure place and roll in both directions with a roller. Proceed to cover the entire floor making sure that the joints are butted tight. After completion, the DuraCork T22 should cover the entire flooring area without gaps and with joints securely taped.

Final Flooring
Always follow manufacturers recommended installation instructions.
DuraCork T22
100% Recycled Impact Noise Reduction Underlay
Low Level
Hardwood  .  Bonded  .  100% Recycled
Installed Directly under the Final Floor
High Walking Comfort with Reduced Thickness
High Durability and Long Term Resilience
Aids Airborne Noise Insulation