Specialists in Acoustic, Access and Leisure Flooring Systems
01274 533311 . firstname.lastname@example.org
Agglomerated Cork Underlay for Impact Noise and Thermal Insulation of Floating Floors. Already Includes Moisture Barrier
1m x 10m x 2mm
*Other sizes available upon request
(ISO 140 & 717)
∆Lw = 20dB
(EPH MFPA Leipzig P4.2/08 – 176)
Thermal Conductivity: 0.038 W/m˚K
Thermal Resistance: 0.053 m²˚K/W
PHYSICAL AND MECHANICAL PROPERTIES
Specific weight: 150-200 Kg/m³
Tensile Strength: >200 KPa
Durability: Lifetime of the Building
GENERAL INSTALLATION INSTRUCTIONS
The following installation instructions are recommended by Durabella Acoustics Limited, but are not intended as a definitive project specification. They are presented in an attempt to be used with recommended installation procedures of the flooring manufacturers.
Temperature >10˚C / Room moisture content < 75%
All subfloor work should be structurally sound, clear and level. The moisture content of the subfloor should not be more than 2.5% (CM) by weight measured on concrete subfloors.
Installation instructions for DuraCork C11PE
Unpack the DuraCork C11PE at least 24h before the installation and store it in the room where the installation will take place. Cut the C11PE to desired length and install directly over the entire floor pulled 30mm up the walls with crown of the rolled materials up (DuraCork label side down), removing all trapped air. Install by overlapping (minimum 100mm) the p.e. foil, and use an adequate tape to adhere/fix it, if necessary. After completion, the C11PE should cover the entire flooring area without gaps and with joints butted tight and preferably taped.
Always follow manufacturers recommended installation instructions.
Nature’s Impact Noise Reduction Underlay
Laminate . Thermal . Natural
Saves one Installation Step
High Durability and Long Term Resilience
Increases Floor Thermal Insulation
Easy to Handle and Install